Home High Security and Challenge Locks (1131) FAB Padlock from Czech Republic

(1131) FAB Padlock from Czech Republic

0
13

LockLab is Fan funded!  Help pay for stuff to review, break and talk trash about, and maybe even give away when we’re done.  Join the Tribe!

My vises are made by Panavise, a U.S. Company.  The one with the wide jaws is the model 350.  The smaller one is the model 301. Both have the 312 Base mount – www.panavise.com

 

Comment(13)

  1. it just goes to show…..locks are meant to keep your friends out…………and not even all of those………

  2. Would have liked to see you rock and rake this lock to see how long that would have taken for you to open it these ways.

  3. So look forward to your videos, still on the hunt for locks and pins. I managed to get a few from friends and family. Saving up for an ultimate adversary lock. Might take a while, but I'll get there.

  4. The accessibility with a thick pick is disappointing. I have a Euro-profile cylinder advertised as class 3 from the same lineup. Not in my door though. It seems to have a better warding than this, but if it also is wider inside, then it's sure good I replaced it with an Evva.

  5. I just got to ask… What is the point of the cuts that are made at the bottom of the key (tip end)? Though it would be some extra pin or something, but i guess not?

Comments are closed.

WP Facebook Auto Publish Powered By : XYZScripts.com